Dish Network BASIC REMOTE Guide de l'utilisateur télécharger pdf (Page 8)

118866 7

SETTING UPTHEREMOTE TO CONTROL YOUR TV

1. Find the brand name of your TV in the TV code

tables starting on page 32. You will be referring to

this location for codes in the instructions below.

2. Turn on your TV.

3. Press and hold until both lights turn

on (it takes about five seconds).

4. Release . light will flash.

5. Press . Notice light turns on and stays on.

6. Enter one of the three-digit codes for your TV from

the TV code tables while light is on.

Note: You have about 20 seconds to begin entering

the TV code.

7. Press the

MUTE button and watch light.

If light flashes three times, the code is valid

and you can go to step 8. If light does not flash

at all, the code may not have been entered

correctly. So, start over from step 3 and try the code

again.

8. Press and your TV should shut off. If your TV

shuts off, go to step 9. If not, pick another code for

your TV brand from the TV Codes table and go

back to step 3. If you have tried all of the codes and

none work, go to How to Scan for TV and VCR

Codes on page 21.

9. Turn your TV back on by pressing again and

try the other buttons below to make sure they work.

• Press the 0 through 9 buttons to change channels

on your TV.

SAT

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 51 52

Pas de commentaire

Dish Network BASIC REMOTE Guide de l'utilisateur Page 8