Dish Network 6.3 Guide de l'utilisateur télécharger pdf (Page 24)

1 to control the TV2 side of your receiver.

7 Press the RECORD button on the green TV1 remote control you

are setting up. If you get a warning that tells you to pick another

address, continue on to the next step. If no warning appears, go to

step 12 of this procedure.

8 On the remote control, press and hold the SAT mode button for

about three seconds, until all the mode buttons light up, and then

let go of the SAT button. The SAT mode button will blink.

9 Use the number buttons to enter any number from 1 to 16, except

for the address shown for on your screen.

Write down the number you entered:

10 Press the POUND (#) button. If you entered the address correctly,

the SAT mode button will flash three times.

11 Make sure the System Information screen shows UHF and

that this address matches the number you entered in step 9.

12 Select Done to close the System Information screen. If

nothing happens, press RECORD, and then select Done.

Remote Addrs.

TV Out

UHF

Note: Highlight the Remote Address (the shaded

area in the graphic above).

6.3 Replacement.book Page 12 Tuesday, November 7, 2006 11:56 AM

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 38 39

Pas de commentaire

Dish Network 6.3 Guide de l'utilisateur Page 24